[PATCH v2 0/3] arm_arch_timer: VDSO preparation, code consolidation

On Mon, Sep 22, 2014 at 04:39:19PM +0100, Will Deacon wrote:

On Thu, Sep 18, 2014 at 03:59:32PM +0100, Nathan Lynch wrote:

quoted

This series contains the necessary changes to allow architected timer
access from user-space on 32-bit ARM.  This allows the VDSO to support
high resolution timestamps for clock_gettime and gettimeofday.  This
also merges substantially similar code from arm and arm64 into the
core arm_arch_timer driver.

The functional changes are:
- When available, CNTVCT is made readable by user space on arm, as it
  is on arm64.
- The clocksource name becomes "arch_mem_counter" if CP15 access to
  the counter is not available.

These changes have been carried as part of the ARM VDSO patch set over
the last several months, but I am splitting them out here as I assume
they should go through the clocksource maintainers.

For the series:

  Acked-by: Will Deacon [off-list ref]

I'm not sure which tree the arch-timer stuff usually goes through, but
the arm/arm64 bits look fine so I'm happy for them to merged together.

I raised a while back with Will whether there's much point to having
this on ARM.  While it's useful for virtualisation, the majority of
32-bit ARM doesn't run virtualised.  So there's little point in having
the VDSO on the majority of platforms - it will just add additional
unnecessary cycles slowing down the system calls that the VDSO is
designed to try to speed up.

So, my view is that this VDSO will only be of very limited use for
32-bit ARM, and should not be exposed to userspace unless there is
a reason for it to be exposed (iow, the hardware necessary to support
it is present.)

-- 
FTTC broadband for 0.8mile line: currently at 9.5Mbps down 400kbps up
according to speedtest.net.