[PATCHv2 1/8] clk: add an APPLY_RATE_CHANGE notifier event during clk_set_rate()

Dear Stephen Boyd,

On Tue, 08 Jul 2014 13:18:54 -0700, Stephen Boyd wrote:

quoted

quoted

quoted

In order to solve this problem, we propose to add an APPLY_RATE_CHANGE
notifier event, which gets called right after ->set_rate(), but before
->recalc_rate(), and therefore regardless of whether there was an
actualy frequency change or not.

Is there any reason why we can't call the pmsu code (part #3) directly
from the cpu clock driver? It seems like if we just called the
.set_rate() op we wouldn't actually have changed the clock's rate. That
doesn't seem very intuitive and it really makes the code flow hard to
follow.

Right, but what solution would you propose to achieve that? These days,
a direct call from drivers/ code to arch/arm/mach-<foo>/ code is
frowned upon, no? (The code handling the PMSU is in
arch/arm/mach-mvebu/pmsu.c).

I don't see a problem with having an include file in include/linux/ for
this, maybe others do though.

I'm fine with that as well, but I believe one of the policy was to
avoid having too much drivers/ stuff call into arch/arm/ stuff.

If it actually is a problem then perhaps
moving the pmsu.c code into drivers/ is the right solution.

Yes, but where would it belong? The PMSU hardware block is tightly
linked to SMP initialization (which means it should be up and running
very early), CPU hotplug, cpuidle, cpufreq and suspend/resume. It means
that it interacts with a lot of different subsystems.

Maybe the solution of adding a direct call from
drivers/clk/mvebu/clk-cpu.c to arch/arm/mach-mvebu/pmsu.c is the
easiest and most explicit solution.

Thanks,

Thomas
-- 
Thomas Petazzoni, CTO, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com