[PATCH v4] clk: qcom: Add support for IPQ8064's global clock controller (GCC)

Quoting Kumar Gala (2014-06-30 09:08:33)

On Jun 17, 2014, at 2:46 PM, Kumar Gala [off-list ref] wrote:

quoted

Add a driver for the global clock controller found on IPQ8064 based
platforms. This should allow most non-multimedia device drivers to probe
and control their clocks.

This is currently missing clocks for USB HSIC and networking devices.

Signed-off-by: Kumar Gala <redacted>
Signed-off-by: Andy Gross <redacted>
Signed-off-by: Stephen Boyd <redacted>
---
v4:
* Fix usb utmi freq clk table
* Fix numbering issue in dt-bindings/clock/qcom,gcc-ipq806x.h

v3:
* Based on APQ8084 clk patches
* Added USB3 and SATA clks
* Minor clean ups (made hex numbers lowercase)

v2:
* dropped audio clock from commit message
* changed Kconfig symbol to IPQ_GCC_806X
* Fixed PXO/CXO clk freq to 25Mhz

.../devicetree/bindings/clock/qcom,gcc.txt         |    1 +
drivers/clk/qcom/Kconfig                           |    8 +
drivers/clk/qcom/Makefile                          |    1 +
drivers/clk/qcom/gcc-ipq806x.c                     | 2424 ++++++++++++++++++++
include/dt-bindings/clock/qcom,gcc-ipq806x.h       |  293 +++
include/dt-bindings/reset/qcom,gcc-ipq806x.h       |  132 ++
6 files changed, 2859 insertions(+)
create mode 100644 drivers/clk/qcom/gcc-ipq806x.c
create mode 100644 include/dt-bindings/clock/qcom,gcc-ipq806x.h
create mode 100644 include/dt-bindings/reset/qcom,gcc-ipq806x.h

Mike,

Any update on pulling this in?

Looks good to me.

What's the story on getting a pull request for qcom clock stuff in the
future? For more mature clock drivers it is nice for a clock maintainer
(maybe Stephen in this case, based on patch count in drivers/clk/qcom?)
to batch up everything. It also helps lazy maintainers like me not have
to review every line of code for the non-controversial stuff.

Regards,
Mike

- k

-- 
Employee of Qualcomm Innovation Center, Inc.
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation