[PATCH 1/2 v3] spi: s3c64xx: use "cs-gpios" from spi node instead of "cs-gpio"

On 11.06.2014 19:27, Javier Martinez Canillas wrote:

On 06/11/2014 01:38 PM, Naveen Krishna Ch wrote:

quoted

On 11 June 2014 16:43, Javier Martinez Canillas
[off-list ref] wrote:

quoted

On 06/11/2014 08:31 AM, Naveen Krishna Chatradhi wrote:

[snip]

quoted

quoted

quoted

              return ERR_PTR(-EINVAL);
      }
+     cs->line = spi->cs_gpio;

I wonder why are you keeping cs->line? AFAICT it's only used in
s3c64xx_spi_setup() to request the GPIO and since you get the struct spi_device
pointer as a parameter then you can just use spi->s_gpio instead.

I'm trying not to touch the non-DT part of the code.

struct s3c64xx_spi_csinfo *cs = spi->controller_data;

This will update the cs->line and cs->fb_delay in case of non-DT.

I see, then I prefer the opposite and do something like this on s3c64xx_spi_probe():

if (!pdev->dev.of_node)
       spi->cs_gpio = cs->line;

Hmm, as far as I understand, spi here is spi_device, not spi_master. I
don't think you have access to SPI devices on your bus in controller
probe().

What I think could work is reworking the driver to:

- in DT case, don't do anything in the driver about the GPIO chip
select, because it will be handled automatically by the core.

- in non-DT case, in s3c64xx_spi_setup(), just take the GPIO pin from
s3c64xx_spi_csinfo struct passed through spi->controller_data, request
it and save it to spi->cs_gpio,

- in non-DT case, in s3c64xx_spi_cleanup(), free the GPIO requested in
s3c64xx_spi_setup() and set spi->cs_gpio to -ENOENT (as done initially
in spi_alloc_device()).

Best regards,
Tomasz