On Wed, Apr 16, 2014 at 05:46:47PM -0500, Rob Herring wrote:

On Wed, Apr 16, 2014 at 3:43 AM, Russell King
[off-list ref] wrote:

quoted

Spread-spectrum doesn't work with Cubox-i hardware, so we have to
disable this feature.  Add a DT property so that platforms can
indicate that this feature should not be enabled.

This is for spread-spectrum tx or rx? Transmit SS is optional to
support, but the receiver must support SS. Otherwise random drives
won't work which makes for a good user experience. Is this really a
board quirk rather than a Si issue?

No idea.  This bit controls clock generation, and one reason given to
disable it is if the reference clock being supplied is already spread
spectrum.  I don't think that applies here.  It doesn't say which
clock(s) this is applied to - I would guess it's the transmit clock.

All I know is that with SS enabled, the drive is not detected, and
SolidRun's original port disables SS.  Disabling SS allows the external
drive to be detected.

I have no capability to check the eye pattern, so I've no idea if
there's a problem with the electrical setup which stops SS from
working.  All I know is with the parameters I give here (which are
those which SolidRun's original port uses) and with SS disabled,
it works.

-- 
FTTC broadband for 0.8mile line: now at 9.7Mbps down 460kbps up... slowly
improving, and getting towards what was expected from it.