On Sun, Feb 23, 2014 at 2:12 AM, Mark Brown [off-list ref] wrote:

On Thu, Feb 20, 2014 at 05:36:02PM +0100, Markus Pargmann wrote:

quoted

Hi,

These two patches replace all ops->enable/disable by
_regulator_do_disable/enable function calls. These wrappers also handle gpio
regulators.

Applied both, thanks.

With these two patches applied I get the following error on
mx6qsabresd running today's linux-next:

vdd1p1: failed to enable
anatop_regulator regulator-1p1.2: failed to register vdd1p1
anatop_regulator: probe of regulator-1p1.2 failed with error -22
vdd3p0: failed to enable
anatop_regulator regulator-3p0.3: failed to register vdd3p0
anatop_regulator: probe of regulator-3p0.3 failed with error -22
vdd2p5: failed to enable
anatop_regulator regulator-2p5.4: failed to register vdd2p5
anatop_regulator: probe of regulator-2p5.4 failed with error -22
vddarm: 725 <--> 1450 mV at 1100 mV
vddpu: 725 <--> 1450 mV at 1100 mV
vddsoc: 725 <--> 1450 mV at 1175 mV
....

pfuze100-regulator 1-0008: Full layer: 1, Metal layer: 0
pfuze100-regulator 1-0008: FAB: 0, FIN: 0
SW1AB: failed to enable
pfuze100-regulator 1-0008: register regulatorSW1AB failed
pfuze100-regulator: probe of 1-0008 failed with error -22


Reverting these two patches the regulators probe successfully.

Any ideas?

Regards,

Fabio Estevam