[PATCH 23/27] clocksource: sh_cmt: Add DT support

Hi Laurent,

On Sat, Feb 15, 2014 at 1:12 AM, Laurent Pinchart
[off-list ref] wrote:

Hi Magnus,

On Saturday 15 February 2014 01:01:30 Magnus Damm wrote:

quoted

On Sat, Feb 15, 2014 at 12:53 AM, Laurent Pinchart wrote:

quoted

On Friday 14 February 2014 10:58:22 Mark Rutland wrote:

quoted

On Fri, Feb 14, 2014 at 01:00:01AM +0000, Laurent Pinchart wrote:

quoted

+Channels Optional Properties:
+
+  - clock-source-rating: rating of the timer as a clock source device.
+  - clock-event-rating: rating of the timer as a clock event device.

This feels like a leak of Linux internals. Why do you need this?

You're right, it is. The clock source and clock event ratings are
currently configured through platform data, I'll need to find a way to
compute them in the driver instead.

That would be very good!

Any pointer would be appreciated :-) How did you compute the various ratings
used in platform data all over the place ?

Historically we used the rating to select between CMT and TMU. For
clock sources I suppose you also have the jiffy rating to consider.
And for the SMP parts we have ARM IP for TWD and arch timers that have
their ratings too. So you need to check all the timers on a particular
system and consider what you want to have operating by default. The
ARM IP timers should be preferred if available. For clock sources the
rule is probably the higher resolution the better.

quoted

quoted

There's still one piece of Linux-specific data I need though, as I need to
specify for each channel whether to use it as a clock source device, a
clock event device, both of them or none. That's configuration
information that needs to be provided somehow.

I think you can decide clock source or clock event assignment based on
number of channels available. If you have only a single channel then both
clock event and clock source need to be supported. Otherwise use one channel
for clock source and the rest for clock events.

That won't match the current situation. Look at CMT0 in r8a7790 for instance.
There's two hardware channels available, and we only use the first one, for
clock events only.

You are correct. The reason for that is that the CMT driver today is
optimized for combined clock event and clock source operation.

Historically the hardware it initially was written for (sh-mobile on
the SH arch) only had a single timer channel so combined operation was
required for tickless to work. But since you're asking how to allocate
channels then I propose checking numbers of channels available and go
from there. With that the r8a7790 support can only get better. =)

quoted

This is probably out of scope for this DT conversion, but it would be neat
if you somehow could specify the CPU affinity for a channel to tie a clock
event to an individual CPU core. This would make a a per-cpu timer unless
I'm mistaken. But that's more of a software policy than anything else.

Yes, that's a configuration that needs to be specified somewhere. I don't know
where though.

As long as you have per-channel interrupts described in DT you can
probably handle this in a generic way in the driver.

Thanks,

/ magnus