[PATCH v4 2/8] at91: pinctrl: don't request GPIOs used for interrupts but lock them as IRQ
From: Jean-Jacques Hiblot <hidden>
Date: 2014-02-12 10:15:11
Also in:
lkml
Subsystem:
pin control subsystem, pin controller - microchip at91, the rest · Maintainers:
Linus Walleij, Ludovic Desroches, Linus Torvalds
During the xlate stage of the DT interrupt parsing, the at91 pinctrl driver requests the GPIOs that are described as interrupt sources. This prevents a driver to request the gpio later to get its electrical value. This patch replaces the gpio_request with a gpio_lock_as_irq to prevent the gpio to be set as an ouput while allowing a subsequent gpio_request to succeed Signed-off-by: Jean-Jacques Hiblot <redacted> --- drivers/pinctrl/pinctrl-at91.c | 5 ++--- 1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/pinctrl/pinctrl-at91.c b/drivers/pinctrl/pinctrl-at91.c
index d990e33..db55b96 100644
--- a/drivers/pinctrl/pinctrl-at91.c
+++ b/drivers/pinctrl/pinctrl-at91.c@@ -1478,18 +1478,17 @@ static int at91_gpio_irq_domain_xlate(struct irq_domain *d, { struct at91_gpio_chip *at91_gpio = d->host_data; int ret; - int pin = at91_gpio->chip.base + intspec[0]; if (WARN_ON(intsize < 2)) return -EINVAL; *out_hwirq = intspec[0]; *out_type = intspec[1] & IRQ_TYPE_SENSE_MASK; - ret = gpio_request(pin, ctrlr->full_name); + ret = gpio_lock_as_irq(&at91_gpio->chip, intspec[0]); if (ret) return ret; - ret = gpio_direction_input(pin); + ret = at91_gpio_direction_input(&at91_gpio->chip, intspec[0]); if (ret) return ret;
--
1.8.5.3