[PATCH V4 2/6] ARM: imx: add suspend in ocram support on i.mx6q

On Mon, Jan 13, 2014 at 07:53:47PM +0800, Anson Huang wrote:

 #ifdef CONFIG_PM
+void imx6_suspend(void);

So, imx6_suspend() takes no arguments.

+static int (*imx6_suspend_in_ocram_fn)(void __iomem *ocram_vbase);

Oh, it takes one argument.

+		/*
+		 * call low level suspend function in ocram,
+		 * as we need to float DDR IO.
+		 */
+		local_flush_tlb_all();
+		imx6_suspend_in_ocram_fn(suspend_ocram_base);

Yes, definitely takes one argument...

+	imx6_suspend_in_ocram_fn = (void *)fncpy(
+		suspend_ocram_base + sizeof(*pm_info),
+		&imx6_suspend,
+		MX6Q_SUSPEND_OCRAM_SIZE - sizeof(*pm_info));

This cast here is needed to work around the above confusion.

+ENTRY(imx6_suspend)
+	ldr	r1, [r0, #PM_INFO_PBASE_OFFSET]
+	ldr	r2, [r0, #PM_INFO_RESUME_ADDR_OFFSET]
+	ldr	r3, [r0, #PM_INFO_CPU_TYPE_OFFSET]
+	ldr	r4, [r0, #PM_INFO_PM_INFO_SIZE_OFFSET]

Yes, definitely takes one argument.

If you fix the prototype for imx6_suspend, you don't need to cast the
result of fncpy().  Casts should always be avoided where possible.

-- 
FTTC broadband for 0.8mile line: 5.8Mbps down 500kbps up.  Estimation
in database were 13.1 to 19Mbit for a good line, about 7.5+ for a bad.
Estimate before purchase was "up to 13.2Mbit".