DT include files (was: [GIT PULL 2/2] ARM: imx: device tree changes for 3.14)

On Sat, Jan 04, 2014 at 09:10:58AM +0800, Shawn Guo wrote:

On Fri, Jan 03, 2014 at 11:29:35AM -0800, Olof Johansson wrote:

quoted

On Thu, Jan 2, 2014 at 7:04 PM, Shawn Guo [off-list ref] wrote:

quoted

On Thu, Jan 02, 2014 at 06:41:30PM -0800, Olof Johansson wrote:

quoted

Ok, then it's probably just the location of the header files that
should be adjusted. Other subsystems have placed them under
include/dt-bindings/<subsystem>, so that's likely a better place for
these as well, don't you think?

I had a little discussion with DT people when the headers were firstly
created.  These pinctrl headers are a little different from the headers
in include/dt-bindings/<subsystem>.  The latter are used by both kernel
and device tree sources, while the pinctrl headers are used by device
tree sources only, so I chose to put them just in the same folder as
dts files.  And DT people are fine with my take.

Since you don't provide references to this I had to go searching for
it. All I find is some discussion from 8 months ago, and quite a bit
of that seems to have been about changing bindings, and some about the
preprocessor behavior. Also, the patches seem to have been too big to
make it out on the lists.

I'd like a fresh look from DT people on this just to make sure no
opinions have changed -- lots of things have changed in the last 8
months w.r.t. DT.

Indeed, it's been quite a long time.  Let me restate my point.  The
include/dt-bindings is introduced as a folder to hold headers that are
referenced by both kernel and DTS.  That's why we create the folder in
the kernel include folder and have arch/arm/boot/dts/include/dt-bindings
being a symbol link to it.  All the headers in there need to be
duplicated between kernel and DTS tree, when we move DTS files into
a separated repository.  Putting DTS local headers into the folder is
absolutely unnecessary, and will only confuse people and bother
ourselves when moving DTS files out of kernel tree.

Just a gentle ping to ensure we do not get the pull request lost.  Or do
you have any further comment?

Shawn