Hi Jason,

On 30/10/13 01:40, Jason Cooper wrote:

On Tue, Oct 29, 2013 at 03:15:53PM +1000, gerg at uclinux.org wrote:

quoted

From: Greg Ungerer <redacted>

Add machine support code for the Freescale IMX50 SoC.

It is very similar to the Freescale IMX53, it contains many of the same
periperhal hardware modules, at the same address offsets as the IMX53.
(Notable exceptions are that the IMX50 contains no CAN bus hardware, less
GPIO, no VPU, it does contain an Electrophoretic display controller though).

So this support code just uses the IMX53 definitions as they are today.
We can add the extra IMX50 definitions in the future when required.

Signed-off-by: Greg Ungerer <redacted>
---
 arch/arm/mach-imx/Makefile     |  1 +
 arch/arm/mach-imx/mach-imx50.c | 46 ++++++++++++++++++++++++++++++++++++++++++
 2 files changed, 47 insertions(+)
 create mode 100644 arch/arm/mach-imx/mach-imx50.c

diff --git a/arch/arm/mach-imx/Makefile b/arch/arm/mach-imx/Makefile
index bbe1f5b..924e117 100644
--- a/arch/arm/mach-imx/Makefile
+++ b/arch/arm/mach-imx/Makefile

@@ -112,6 +112,7 @@ obj-$(CONFIG_MACH_EUKREA_CPUIMX51SD) += mach-cpuimx51sd.o
 obj-$(CONFIG_MACH_EUKREA_MBIMXSD51_BASEBOARD) += eukrea_mbimxsd51-baseboard.o
 
 obj-$(CONFIG_MACH_IMX51_DT) += imx51-dt.o
+obj-$(CONFIG_SOC_IMX50) += mach-imx50.o
 obj-$(CONFIG_SOC_IMX53) += mach-imx53.o
 
 obj-$(CONFIG_SOC_VF610) += clk-vf610.o mach-vf610.o

diff --git a/arch/arm/mach-imx/mach-imx50.c b/arch/arm/mach-imx/mach-imx50.c

...

quoted

+static const char *imx50_dt_board_compat[] __initdata = {
+	"fsl,imx50",
+	NULL
+};

Wasn't this going to be consolidated with mach-imx53.c by adding this
compat string to it?

I am still looking at doing that.

Regards
Greg