[PATCH v3 4/6] ARM: dts: imx6q{dl}: fix the wrong RTS/CTS pad name
From: Lothar Waßmann <hidden>
Date: 2013-07-08 07:32:16
Also in:
linux-serial
Hi, Huang Shijie writes:
? 2013?07?07? 19:51, Lothar Wa?mann ??:quoted
Hi, Shawn Guo writes:quoted
On Fri, Jul 05, 2013 at 02:12:30PM +0800, Huang Shijie wrote:quoted
There is something wrong with the RTS/CTS pads: The RTS pad is assigned with the CTS's value; while the CTS pad is assigned with the RTS's value.So basically, you are saying that select_input should be set up for CTS rather than RTS. It seems that the people who generated the macro got the wrong input from developer.programming 'select_input' only makes sense for inputs, not outputs. Since CTS is an output signal, select_input only makes sense for the RTS function of the pads.Hi Lothar: In our imx6 Soc, the CTS is used as a input signal, not as a output signal. I checked two boards, one is imx6q ARM2 armidillo board, one is imx6-sabreauto board, both the boards use the CTS as a input signal.
that's the problem with the DTE/DCE mode. Depending on the DCEDTE bit in the UARTx_UFCR we would need different pad configurations for RTS/CTS because in DCE mode CTS is an output and in DTE mode it's an input. Thus the correct pad config value would need the input_sel on the CTS pad definition for DTE mode and on the RTS pad definition for DCE mode. Maybe something like: #define MX6Q_PAD_EIM_D19__UART1_DCE_CTS_B 0x09c 0x3b0 0x000 0x4 0x0 #define MX6Q_PAD_EIM_D19__UART1_DCE_RTS_B 0x09c 0x3b0 0x91c 0x4 0x0 #define MX6Q_PAD_EIM_D19__UART1_DTE_CTS_B 0x09c 0x3b0 0x91c 0x4 0x0 #define MX6Q_PAD_EIM_D19__UART1_DTE_RTS_B 0x09c 0x3b0 0x000 0x4 0x0 Lothar Wa?mann -- ___________________________________________________________ Ka-Ro electronics GmbH | Pascalstra?e 22 | D - 52076 Aachen Phone: +49 2408 1402-0 | Fax: +49 2408 1402-10 Gesch?ftsf?hrer: Matthias Kaussen Handelsregistereintrag: Amtsgericht Aachen, HRB 4996 www.karo-electronics.de | info at karo-electronics.de ___________________________________________________________