---

In v3, use IRQ_TYPE_LEVEL_HIGH in the example, as suggested by Laurent.

 .../devicetree/bindings/net/wireless/ti-wilink.txt | 68
++++++++++++++++++++++ 1 file changed, 68 insertions(+)
 create mode 100644
Documentation/devicetree/bindings/net/wireless/ti-wilink.txt

diff --git a/Documentation/devicetree/bindings/net/wireless/ti-wilink.txt

b/Documentation/devicetree/bindings/net/wireless/ti-wilink.txt new file
mode 100644
index 0000000..aafebb1

--- /dev/null
+++ b/Documentation/devicetree/bindings/net/wireless/ti-wilink.txt

@@ -0,0 +1,68 @@
+TI WiLink Wireless Modules Device Tree Bindings
+===============================================
+
+The WiLink modules provide wireless connectivity, such as WLAN,
+Bluetooth, FM and NFC.
+
+There are several different modules available, which can be grouped by
+their generation: WiLink6, WiLink7 and WiLink8.  WiLink4 is not
+currently supported with device tree.
+
+Currently, only the WLAN portion of the modules is supported with
+device tree.
+
+Required properties:
+--------------------
+
+- compatible: should be "ti,wilink6", "ti,wilink7" or "ti,wilink8"
+- interrupt-parent: the interrupt controller
+- interrupts: out-of-band WLAN interrupt
+	See the interrupt controller's bindings documentation for
+	detailed definition.
+
+Optional properties:
+--------------------
+
+- clocks: list of clocks needed by the chip as follows:
+
+  refclock: the internal WLAN reference clock frequency (required for
+	WiLink6 and WiLink7; not used for WiLink8).
+
+  tcxoclock: the internal WLAN TCXO clock frequency (required for
+	WiLink7 not used for WiLink6 and WiLink8).
+
+  The clocks must be defined and named accordingly.  For example:
+
+  clocks = <&refclock>
+  clock-names = "refclock";
+
+  refclock: refclock {
+		     compatible = "ti,wilink-clock";
+		     #clock-cells = <0>;
+		     clock-frequency = <38400000>;
+	};
+
+  Some modules that contain the WiLink chip provide clocks in the
+  module itself.  In this case, we define a "ti,wilink-clock" as shown
+  above.  But any other clock could in theory be used, so the proper
+  clock definition should be used.
+
+
+Example:
+--------
+
+Example definition that can be used in OMAP4 Panda:
+
+wlan {
+	compatible = "ti,wilink6";
+	interrupt-parent = <&gpio2>;
+	interrupts = <21 IRQ_TYPE_LEVEL_HIGH>;	/* gpio line 53 */
+	clocks = <&refclock>;
+	clock-names = "refclock";
+
+	refclock: refclock {
+		compatible = "ti,wilink-clock";
+		#clock-cells = <0>;
+		clock-frequency = <38400000>;
+	};
+};