[PATCH v3 00/12] ARM: samsung-time: Prepare for multiplatform support

On Saturday 09 of March 2013 21:23:09 Tomasz Figa wrote:

This series is an attempt to make the samsung-time clocksource driver
ready for multiplatform kernels. It moves the driver to
drivers/clocksource, cleans it up from uses of static platform-specific
definitions, simplifies timer interrupt handling and adds Device Tree
support.

Tested on a Tiny6410 board (Mini6410-compatible) both with and without
Devicee Tree (with my DT patches for S3C64xx). Compile tested for other
related SoCs.

Changes since v2:
(http://thread.gmane.org/gmane.linux.kernel.samsung-soc/16158)
 - Addressed comments from Rob Herring and Mark Rutland
 - Removed unused register definitions
 - Replaced samsung,source-timer and samsung,event-timer properties
   with samsung,pwm-outputs property that defines which PWM channels
   are reserved for PWM outputs on particular platform
 - Split non-DT and DT initialization into two functions
 - Fixed a copy paste error

Changes since v1:
(http://thread.gmane.org/gmane.linux.kernel.samsung-soc/16005)
 - Addressed comments from Mark Rutland
 - Documented struct samsung_timer_variant
 - Dropped inactive mail addresses from CC

Tomasz Figa (12):
  ARM: SAMSUNG: Move samsung-time to drivers/clocksource
  clocksource: samsung-time: Set platform-specific parameters at runtime
clocksource: samsung-time: Drop useless defines from public header ARM:
SAMSUNG: Move samsung-time.h header to inlude/clocksource clocksource:
samsung-time: Use local register definitions
  clocksource: samsung-time: Remove use of static register mapping
  clocksource: samsung-time: Use clk_get_sys for getting clocks
  ARM: SAMSUNG: devs: Drop unnecessary IRQ resources of timer devices
  clocksource: samsung-time: Do not use static IRQ definition
  clocksource: samsung-time: Move IRQ mask/ack handling to the driver
  ARM: SAMSUNG: Remove unused PWM timer IRQ chip code
  clocksource: samsung-time: Add Device Tree support

Well, since this series is not merged yet, I would suggest to refrain from 
merging this version.

By the way of my other works, I have found that the case of samsung 
pwm/timer is a bit more complex than it initially seemed and it has to be 
done in a different way, to coordinate two separate drivers accessing the 
same hardware (samsung-time and pmw-samsung).

I'm currently working on next version, which is going to rework the pwm-
samsung driver as well.

Best regards,
Tomasz