[PATCH 1/2] gpio/omap: convert gpio irq domain to linear mapping

On 03/02/2013 05:48 AM, Felipe Balbi wrote:

On Fri, Mar 01, 2013 at 11:22:47AM -0600, Jon Hunter wrote:

quoted

Currently the OMAP GPIO driver uses a legacy mapping for the GPIO IRQ
domain. This is not necessary because we do not need to assign a
specific interrupt number to the GPIO IRQ domain. Therefore, convert
the OMAP GPIO driver to use a linear mapping instead.

Please note that this also allows to simplify the logic in the OMAP
gpio_irq_handler() routine, by using irq_find_mapping() to obtain the
virtual irq number from the GPIO bank and bank index.

Reported-by: Linus Walleij <redacted>
Signed-off-by: Jon Hunter <redacted>

Reviewed-by: Felipe Balbi <redacted>

Just one suggestion below for a later patch.

quoted

@@ -680,7 +686,7 @@ static void gpio_irq_handler(unsigned int irq, struct irq_desc *desc)
 {
 	void __iomem *isr_reg = NULL;
 	u32 isr;
-	unsigned int gpio_irq, gpio_index;
+	unsigned int i;
 	struct gpio_bank *bank;
 	int unmasked = 0;
 	struct irq_chip *chip = irq_desc_get_chip(desc);

@@ -721,15 +727,10 @@ static void gpio_irq_handler(unsigned int irq, struct irq_desc *desc)
 		if (!isr)
 			break;
 
-		gpio_irq = bank->irq_base;
-		for (; isr != 0; isr >>= 1, gpio_irq++) {
-			int gpio = irq_to_gpio(bank, gpio_irq);
-
+		for (i = 0; isr != 0; isr >>= 1, i++) {
 			if (!(isr & 1))
 				continue;

this will iterate over all 32 GPIOs, a better way to handle this would
be to have something like:

Worse case, if only bit 31 was set then I agree this is not that
efficient. Or even if one bit is set. However, the loop itself will
iterate while isr != 0 so not always over each bit. No different to the
existing code.

while (isr) {
	unsigned long bit = __ffs(isr);

	/* clear this bit */
	isr &= ~bit;

	generic_handle_irq(irq_find_mapping(bank->domain, bit);
}

this way you will only iterate the amount of bits enabled in the isr
register.

Definitely cleaner but I am wondering which approach would be more
efficient from an instruction standpoint. This could definitely be much
more efficient if there is only a couple bits set.

ps: completely untested ;-)

No problem. Thanks for the inputs.

Cheers
Jon