[PATCH v2 00/12] ARM: samsung-time: Prepare for multiplatform support

Hi Heiko,

On Sunday 17 of February 2013 17:05:54 Heiko St?bner wrote:

Am Sonntag, 17. Februar 2013, 00:05:07 schrieb Heiko St?bner:

quoted

Am Samstag, 16. Februar 2013, 17:43:52 schrieb Tomasz Figa:

quoted

This series is an attempt to make the samsung-time clocksource
driver
ready for multiplatform kernels. It moves the driver to
drivers/clocksource, cleans it up from uses of static
platform-specific
definitions, simplifies timer interrupt handling and adds Device
Tree
support.

Tested on a Tiny6410 board (Mini6410-compatible) both with and
without
Devicee Tree (with my DT patches for S3C64xx). Compile tested for
other
related SoCs.

Changes since v1:
(http://thread.gmane.org/gmane.linux.kernel.samsung-soc/16005)

 - Addressed comments from Mark Rutland
 - Documented struct samsung_timer_variant
 - Dropped inactive mail addresses from CC

Tomasz Figa (12):
  ARM: SAMSUNG: Move samsung-time to drivers/clocksource
  clocksource: samsung-time: Set platform-specific parameters at
  runtime
  clocksource: samsung-time: Drop useless defines from public header
  ARM: SAMSUNG: Move samsung-time.h header to inlude/clocksource
  clocksource: samsung-time: Use local register definitions
  clocksource: samsung-time: Remove use of static register mapping
  clocksource: samsung-time: Use clk_get_sys for getting clocks
  ARM: SAMSUNG: devs: Drop unnecessary IRQ resources of timer
  devices
  clocksource: samsung-time: Do not use static IRQ definition
  clocksource: samsung-time: Move IRQ mask/ack handling to the
  driver
  ARM: SAMSUNG: Remove unused PWM timer IRQ chip code
  clocksource: samsung-time: Add Device Tree support

on a non-dt s3c2416 based board
Tested-by: Heiko Stuebner <heiko@sntech.de>


once I've ported my s3c2416 dt patches to all the recent changes, I
will also test the dt side.

also on my upcoming s3c2416 dt patches the clocksource works like a
charm, so to update:

on a s3c2416 based board both with and without devicetree
Tested-by: Heiko Stuebner <heiko@sntech.de>

Thank you for your testing.

Best regards,
Tomasz