Hi Sourav,

On Mon, 2013-01-28 at 16:47 +0530, Sourav Poddar wrote:

Booting 3.8-rc4 om omap 4430sdp results in the following error

omap_i2c 48070000.i2c: did not get pins for i2c error: -19
[    1.024261] omap_i2c 48070000.i2c: bus 0 rev0.12 at 100 kHz
[    1.030181] omap_i2c 48072000.i2c: did not get pins for i2c error: -19
[    1.037384] omap_i2c 48072000.i2c: bus 1 rev0.12 at 400 kHz
[    1.043762] omap_i2c 48060000.i2c: did not get pins for i2c error: -19
[    1.050964] omap_i2c 48060000.i2c: bus 2 rev0.12 at 100 kHz
[    1.056823] omap_i2c 4807a000.i2c: did not get pins for i2c error: -19
[    1.064025] omap_i2c 4807a000.i2c: bus 3 rev0.12 at 400 kHz

This happens because omap4 dts file is not adapted to use i2c through pinctrl
framework. Populating i2c pinctrl data to get rid of the error.

Tested on omap4430 sdp with 3.8-rc4 kernel.

Signed-off-by: Sourav Poddar <redacted>
Reported-by: Santosh Shilimkar <redacted>
---

Could you do the same thing for panda? I'm getting the same kind of
errors with it:

[    0.000000] Machine: Generic OMAP4 (Flattened Device Tree), model: TI OMAP4 PandaBoard               
[...]
[    2.884826] omap_i2c 48072000.i2c: did not get pins for i2c error: -19                               
[    2.890686] omap_i2c 48072000.i2c: bus 1 rev0.11 at 400 kHz                                          
[    2.892028] omap_i2c 48060000.i2c: did not get pins for i2c error: -19                               
[    2.899047] omap_i2c 48060000.i2c: bus 2 rev0.11 at 100 kHz                                          
[    2.906677] omap_i2c 48350000.i2c: did not get pins for i2c error: -19                               
[    2.912872] omap_i2c 48350000.i2c: bus 3 rev0.11 at 400 kHz                                          

--
Cheers,
Luca.