On 20/12/12 14:42, Hiroshi Doyu wrote:

Marc Zyngier [off-list ref] wrote @ Thu, 20 Dec 2012 14:32:21 +0100:

quoted

On 20/12/12 12:55, Peter De Schrijver wrote:

quoted

On Thu, Dec 20, 2012 at 01:33:42PM +0100, Marc Zyngier wrote:

quoted

On 20/12/12 12:22, Peter De Schrijver wrote:

quoted

quoted

quoted

quoted

quoted

+
+	/* CNTFRQ */
+	asm("mcr p15, 0, %0, c14, c0, 0\n" : : "r" (freq));
+	asm("mrc p15, 0, %0, c14, c0, 0\n" : "=r" (val));
+	BUG_ON(val != freq);

This is scary. CNTFRQ is only writable from secure mode, and will
explode in any other situation.

Also, writing to CNTFRQ doesn't change the timer frequency! This is just
a way for secure mode to tell the rest of the world the frequency the
timer is ticking at. Unless you've wired the input clock to be able to
change the frequency?

ATM, our upstream kernel is expected in secure mode. This situation
may be changed later, though....

I appreciate this. But I expect this kernel to be also used on the
non-secure side if someone tried to run KVM with it. And this would go
bang right away.

But the guest wouldn't necessarily have this peripheral, or any other Tegra114
peripheral for that matter?

The problem is not so much the guest but the host. The host has to be
booted in non-secure, so just saying "we do not support non-secure" is
not a very convincing argument.

Unless of course you've already decided that you don't want to support
KVM on this SoC...

I guess that means we can't support KVM yet. Tegra does not have a secure
monitor by default. It all depends on what that system integrator does.

VExpress doesn't have a secure monitor either, and yet we run KVM on it
(by switching to non-secure before loading the kernel). Same for Exynos5.

What I'm trying to say is that this code is rather pointless (this
should be done by the firmware/bootloader, not the kernel, or the
information should be provided in DT if CNTFRQ is not set).

"tegra114.dtsi" has the folloiwng "tsc" entry. So can we consider that
if dts has this entry, CNTFRQ is not set, which implies it's in secure
mode. kernel should set it up by itself? Otherwise, skip this setup
and use it. For example:

 	tsc {
 		compatible = "nvidia,tegra114-tsc";
 		reg = <0x700f0000 0x20000>;
+		setup-cntfrq;
 	};

Is this what you explained in the above?
At least, kernel can survive without bootloader/firmware support, ATM.

No. The DT should only describe the hardware, and not something that is
Linux specific.

Just use the "clock-frequency" attribute in the timer arch-timer node,
and get rid of this CNTFRQ setting. The driver already knows how to deal
with this situation if this attribute is set.

Thanks,

	M.
-- 
Jazz is not dead. It just smells funny...