[PATCH v3] ARM: zynq: Allow UART1 to be used as DEBUG_LL console.

2012/11/5 Josh Cartwright [off-list ref]:

On Mon, Nov 05, 2012 at 04:45:49PM -0500, Nick Bowler wrote:

quoted

The main UART on the Xilinx ZC702 board is UART1, located at address
e0001000.  Add a Kconfig option to select this device as the low-level
debugging port.  This allows the really early boot printouts to reach
the USB serial adaptor on this board.

For consistency's sake, add a choice entry for UART0 even though it is
the the default if UART1 is not selected.

Signed-off-by: Nick Bowler <redacted>
Tested-by: Josh Cartwright <redacted>
---
Sorry all for the phenominal delay in sending this out.  Josh, I kept
your Tested-By since this version is Obviously Equivalent??? to v2...

I re-tested again just in case and everything is good.

Thanks guys, Applied.

Michal