OMAP baseline test results for v3.7-rc2

Hi Paul,

On 10/20/2012 04:26 PM, Paul Walmsley wrote:

Here are some basic OMAP test results for Linux v3.7-rc2.
Logs and other details at:

    http://www.pwsan.com/omap/testlogs/test_v3.7-rc2/20121020134755/


Passing tests
-------------

Boot to userspace: 3517evm, 3530es3beagle, 3730beaglexm, 37xxevm,
                   4430es2panda, 5912osk, am335xbone

PM ret/off, suspend + dynamic idle: (none)


Failing tests: fixed by posted patches
--------------------------------------

Boot tests:

* 2430sdp: vfp_reload_hw oops during MMC initialization
  - Kernel attempts to save FP registers that don't exist; fix posted:
    - http://www.spinics.net/lists/arm-kernel/msg200646.html

* 2420n800: boot hangs during UART initialization
  - http://lkml.org/lkml/2012/9/11/454
  - Apparently fixed by http://marc.info/?l=linux-omap&m=135068547918479&w=2

* AM335x Beaglebone: omap2plus_defconfig kernels don't boot
  - due to a GPMC bug
  - Apparently fixed by http://www.spinics.net/lists/arm-kernel/msg200787.html

This is now addressed and I have verified it is booting on v3.7-rc2. The
following patch address this boot problem ...

http://git.kernel.org/?p=linux/kernel/git/torvalds/linux-2.6.git;a=commit;h=8119024ef7363591fd958ec89ebfaee7c18209e3

Other:

* 2420N800: powers down 30 seconds after boot
  - Presumably due to missing CBUS patches for watchdog control
  - http://lkml.org/lkml/2012/9/3/265

* 4430es2panda: omap_hwmod: mcpdm: cannot be enabled for reset (3)
  - clock source is from an external I2C-controlled source
  - must skip reset until the switchover to hwmod late init 
  - http://www.spinics.net/lists/arm-kernel/msg178138.html


Failing tests: needing investigation
------------------------------------

Boot tests:

* CM-T3517: L3 in-band error with IPSS during boot
  - Cause unknown but see http://marc.info/?l=linux-omap&m=134833869730129&w=2
  - Longstanding issue; does not occur on the 3517EVM

* 3517EVM & CM-T3517: boot hangs with NFS root
  - Likely some Kconfig, board file, and PM issues with EMAC

* CM-T3517: boot hangs with MMC boot
  - Due to missing MMC setup in board file

* 4460pandaes: boot fails early
  - Appears to be timer-related

I tried v3.7-rc2 on my pandaES and it is booting fine for me.

I have an OMAP4460 ES1.1 and u-boot release 2012.10.

I don't wish to create more work for you, but it could be good to add
silicon revision, u-boot release (if applicable) and toolchain used for
any failures.

Cheers
Jon