[PATCH v2 1/4] ARM: dts: omap5: Update GPIO with address space and interrupts

On 10/23/2012 04:49 PM, Jon Hunter wrote:

Hi Seb,

On 10/23/2012 03:37 AM, Sebastien Guiriec wrote:

quoted

Add base address and interrupt line inside Device Tree data for
OMAP5

Signed-off-by: Sebastien Guiriec <redacted>
---
 arch/arm/boot/dts/omap5.dtsi |   16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/arch/arm/boot/dts/omap5.dtsi b/arch/arm/boot/dts/omap5.dtsi
index 42c78be..9e39f9f 100644
--- a/arch/arm/boot/dts/omap5.dtsi
+++ b/arch/arm/boot/dts/omap5.dtsi

@@ -104,6 +104,8 @@
 
 		gpio1: gpio at 4ae10000 {
 			compatible = "ti,omap4-gpio";
+			reg = <0x4ae10000 0x200>;
+			interrupts = <0 29 0x4>;
 			ti,hwmods = "gpio1";
 			gpio-controller;
 			#gpio-cells = <2>;

I am wondering if we should add the "interrupt-parent" property to add
nodes in the device-tree source. I know that today the interrupt-parent
is being defined globally, but when device-tree maps an interrupt for a
device it searches for the interrupt-parent starting the current device
node.

So in other words, for gpio1 it will search the gpio1 binding for
"interrupt-parent" and if not found move up a level and search again. It
will keep doing this until it finds the "interrupt-parent".

Therefore, I believe it will improve search time and hence, boot time if
we have interrupt-parent defined in each node.

Mmm, I'm not that sure. it will increase the size of the blob, so
increase the time to load it and then to parse it. Where in the current
case, it is just going up to the parent node using the already
un-flatten tree in memory and thus that should not take that much time.

That being said, it might be interesting to benchmark that to see what
is the real impact.

Regards,
Benoit