[PATCH V2 1/2] hwmon: Add devicetree bindings to gpio-fan

On Mon, 10 Sep 2012, Andrew Lunn wrote:

On Mon, Sep 10, 2012 at 02:51:51PM +0100, Jamie Lentin wrote:

quoted

Allow a gpio-fan to be defined in devicetree, see binding documentation
for details.

Changes since V1:-
* Don't hide return codes [Guenter Roeck]
* Remove typecast noise [Guenter Roeck]
* Use of_find_property instead of counting u32s [Guenter Roeck]
* Don't count GPIOs twice [Andrew Lunn]
* Use of_prop_next_u32 to get records in a more obvious fashion
* Use CONFIG_OF_GPIO instead of CONFIG_OF
* Apply __devinitdata to of_gpio_fan_match [Andrew Lunn]

Signed-off-by: Jamie Lentin <redacted>
---
 .../devicetree/bindings/gpio/gpio-fan.txt          |   25 +++++
 drivers/hwmon/gpio-fan.c                           |  116 ++++++++++++++++++++
 2 files changed, 141 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/gpio/gpio-fan.txt

Hi Jamie

Thanks for addressing all the issues raised. However...

Anything before the --- ends up in the changelog entry. Anything
afterwards does not.

The changes you made to address review comments is not something for
the changelog, so Changes since V1:- should be after the --- .

Okay, whilst I was submitting the initial DT support it was suggested by 
Grant Likely they should be above the '---'. I think I prefer this also, 
but I'll go with whatever is more likely to get patches accepted :)

Can resend with the content jiggled if you want, but will put them after 
the '---' in future.

There is more detail in Documentation/SubmittingPatches

     Andrew

-- 
Jamie Lentin