[PATCH 0/2] imx6q: pwm: Activate stop_mode and remove auto enable after configuration

This patch series enables support for pwm driver on imx6q SoC. The first
patch of the series configure the pinctrl for pwm in device-tree. Actually
they are several pin who can be set to pwmO for each pwm, so I assume that
all of them must be enabled when configuring pin.
The second patch activate stop_enable mode and unset the enable bit during
configuration of pwm, and set the enable bit in pwm CR register during enable.

Samir Hachimi (2):
imx6q: Configure the pwm node for pinmux support.
imx6q: Set pwm control register during enable and config call
---
 arch/arm/boot/dts/imx6q.dtsi  |   50 ++++++++
 arch/arm/mach-imx/clk-imx6q.c |    4 ++++
 drivers/pwm/pwm-imx.c         |   37 ++++++++++++++++++++++++++-----------
 3 files changed, 80 insertions(+), 11 deletions(-)