[GIT PULL] io.h clean-up for PCI

On 07/30/2012 09:31 AM, Russell King - ARM Linux wrote:

On Mon, Jul 30, 2012 at 06:05:04AM -0500, Rob Herring wrote:

quoted

On 07/28/2012 09:38 AM, Will Deacon wrote:

quoted

Hi Rob,

On Fri, Jul 27, 2012 at 10:59:18PM +0100, Rob Herring wrote:

quoted

Please pull updated io.h cleanup for PCI branch. I rebased this as the
changes shifted things around a bit. This has the following changes:

- Incorporated fixes from you and Stephen
- Add early i/o mapping pci_map_io_early and enable on footbridge and
integrator for VGA console

Unfortunately, I still experience the same hang on integrator with this
revised patch series. Given the turnaround time for testing this, I don't
think this should block the series, but I would like to get to the bottom of
it if possible.

I tried annotating the PCI code (including fault handlers) and the VGA
console code but I couldn't find the culprit. I suppose the next step is
JTAG, but that requires steal^Wborrowing some hardware from work.

I did do some tests with qemu by adding i/o setup to integrator/cp.
Without it, I would abort on 0xfee003xx (vga regs). Once I added the
setup, I got to an abort on a PCI memory address which I did not setup.

We can always revert integrator change if we can figure this out...

Err, Integrator/CP doesn't have PCI nor does it have VGA.  Only the
Integrator/AP has that.

Yes, I know. But there is no AP model within qemu. I added the mapping
to AP and enabled VGA console to do some basic checks that i/o accesses
happen. It didn't really have to be integrator platform at all for this
test. I know it's not much of a test, but it's something beyond
compiling and staring at the code.

I've also tested PCI i/o with versatile under qemu.

Rob