[RFC 0/3] Add cyclic DMA support to OMAP DMA engine driver

+ Peter,

On Wed, Jun 27, 2012 at 5:10 PM, Mark Brown
[off-list ref] wrote:

On Mon, Jun 25, 2012 at 12:18:47PM +0100, Russell King - ARM Linux wrote:

quoted

It appears to be something to do with the jack detection that's going wrong.
If I start the audio with the jack disconnected, I never get anything out
of the board.  It requires the jack to be connected before the first use.
The on-board speakers used to work without the jack plugged in at one time
but they seem to be completely non-functional now.

quoted

Confused.

Me too - there's nothing obvious in the code just from inspection that
would affect this.

Does audio work with $subject series after your mux fixes which
you posted recently.

Regards
Santosh