[PATCH v3 00/12] add imx usb driver for mx28/6x

On Tue, Jun 05, 2012 at 06:02:13PM +0300, Felipe Balbi wrote:

Hi,

On Fri, May 25, 2012 at 10:24:13AM +0800, Richard Zhao wrote:

quoted

The work is based on  ci13xxx rework done by Alexander Shishkin.

Status:
  - this version only support host
  - usbotg controler works at host role

Changes since V2:
  - Rebase to Alex's tree
  - Use regulator to control vbus power
  - Remove ARCH check in Kconfig, but add OF_DEV check.
  - Other changes according laster version comments.

Richard Zhao (12):
  usb: otg: add notify_connect/notify_disconnect callback
  usb: chipidea: permit driver bindings pass phy pointer
  usb: ehci-hcd: notify phy when connect change
  usb: otg: add basic mxs phy driver support
  usb: chipidea: add imx platform driver
  ARM: imx6q: correct device name of usbphy and usb controller clock
    export
  ARM: imx6q: add config-on-boot gpios
  ARM: imx6q: add usbphy clocks
  ARM: imx6q: disable usb charger detector
  ARM: dts: imx6q-sabrelite: add usb devices
  ARM: mxs: clk_register_clkdev mx28 usb clocks
  ARM: dts: imx28-evk: add usb devices

how are we going to handle these series ? drivers/usb/otg/* parts are
mostly ok (I need to look deeper) but if I take drivers/usb/otg/* we
will have to delay drivers/usb/chipidea I guess...

So someone would have to take the whole series ? Who will be that
person? Alex, will it be you ?

I'm unsure about drivers/usb part, but arch/arm part should go via
arm-soc tree.

-- 
Regards,
Shawn