[PATCH] ARM: at91: add support for Telit GE863-PRO3 Evaluation Kit

On Fri, Mar 30, 2012 at 4:23 PM, Jean-Christophe PLAGNIOL-VILLARD
[off-list ref] wrote:

On 15:01 Fri 30 Mar ? ? , Fabio Porcedda wrote:

quoted

On Fri, Mar 30, 2012 at 1:59 PM, Jean-Christophe PLAGNIOL-VILLARD
[off-list ref] wrote:

quoted

tks for the patch but now we have close the non dt board for this soc

Thanks for the reply.

quoted

and for 3.5 nearly all the devices of this soc will converted to DT

so you need to switch to DT too

Ok, i will switch to DT too.
Do you plan to add support to any 9260 board to the board-dt.c for 3.5?
I think that, as far as there is a working 9260 board using DT, i can
work on the GE863-PRO3 support using DT.

you have 9g20 as 9g20 and 9260 have the same IP you can use it

Ok i try with the 9g20 support.

I don't known when I'll put one bbut it will be a Calao platform

Best Regards,
J.

quoted

quoted

As today I've not finished the pinctrl support you need to do all the pin mux
in the bootlader. For 3.5 it will not be the case anymore

I think i wait for the 3.5 uptated dt stuff.

quoted

quoted

Best Regards,
J.

Thanks and regards
-- 
Fabio Porcedda