On 4/24/12, Andrew Lunn [off-list ref] wrote:

   This is wrong. Not having the clk is not fatal. The old code would
   carefully not call clk_enable(), since it has an error pointer, not
   have a valid clk, and would also not call clk_disable during
   removal.

Whatever i wrote was intentional, because i didn't had this expectation
of yours. :(
Please see if following is fine:

From: Viresh Kumar <redacted>
Date: Sat, 21 Apr 2012 11:16:53 +0530
Subject: [PATCH V3 Resend] ata/sata_mv: Remove conditional compilation
of clk code

With addition of dummy clk_*() calls for non CONFIG_HAVE_CLK cases in clk.h,
there is no need to have clk code enclosed in #ifdef CONFIG_HAVE_CLK, #endif
macros.

Signed-off-by: Viresh Kumar <redacted>
Cc: Jeff Garzik <redacted>
Cc: Andrew Lunn <andrew@lunn.ch>
Cc: linux-ide at vger.kernel.org
---
 drivers/ata/sata_mv.c |   10 ----------
 1 files changed, 0 insertions(+), 10 deletions(-)

diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c
index 7336d4a..37503b8 100644
--- a/drivers/ata/sata_mv.c
+++ b/drivers/ata/sata_mv.c

@@ -551,9 +551,7 @@ struct mv_host_priv {
 	u32			irq_mask_offset;
 	u32			unmask_all_irqs;

-#if defined(CONFIG_HAVE_CLK)
 	struct clk		*clk;
-#endif
 	/*
 	 * These consistent DMA memory pools give us guaranteed
 	 * alignment for hardware-accessed data structures,

@@ -4063,13 +4061,11 @@ static int mv_platform_probe(struct

platform_device *pdev)
 				   resource_size(res));
 	hpriv->base -= SATAHC0_REG_BASE;

-#if defined(CONFIG_HAVE_CLK)
 	hpriv->clk = clk_get(&pdev->dev, NULL);
 	if (IS_ERR(hpriv->clk))
 		dev_notice(&pdev->dev, "cannot get clkdev\n");
 	else
 		clk_enable(hpriv->clk);
-#endif

 	/*
 	 * (Re-)program MBUS remapping windows if we are asked to.

@@ -4096,12 +4092,10 @@ static int mv_platform_probe(struct

platform_device *pdev)
 		return 0;

 err:
-#if defined(CONFIG_HAVE_CLK)
 	if (!IS_ERR(hpriv->clk)) {
 		clk_disable(hpriv->clk);
 		clk_put(hpriv->clk);
 	}
-#endif

 	return rc;
 }

@@ -4117,17 +4111,13 @@ err:
 static int __devexit mv_platform_remove(struct platform_device *pdev)
 {
 	struct ata_host *host = platform_get_drvdata(pdev);
-#if defined(CONFIG_HAVE_CLK)
 	struct mv_host_priv *hpriv = host->private_data;
-#endif
 	ata_host_detach(host);

-#if defined(CONFIG_HAVE_CLK)
 	if (!IS_ERR(hpriv->clk)) {
 		clk_disable(hpriv->clk);
 		clk_put(hpriv->clk);
 	}
-#endif
 	return 0;
 }