Olof Johansson wrote at Sunday, February 26, 2012 3:14 PM:

On Sun, Feb 26, 2012 at 1:51 PM, Olof Johansson [off-list ref] wrote:

quoted

On Wed, Feb 01, 2012 at 04:29:56PM -0700, Stephen Warren wrote:

quoted

For now, this just sets up the pinmux and GPIOs required for the SD
card slot.

Signed-off-by: Stephen Warren <redacted>
---
v2:
* Set PULL_UP for CMD and DATA pins on SD interface
* Add power GPIO for SDMMC1
* Add pinmux configuration for SDMMC4

This will hopefully be replaced by the pinmux DT binding in the near
future, but until that happens, Tegra30 pinmux functionality needs to
be exposed somehow to unblock getting drivers tested on Tegra30.

Thanks, applied to for-3.4/boards.

...and I'm two for two on sending the apply email before I have
checked dependencies.

This doesn't build, so I dropped it again. Probably a missing
dependency on pinctrl changes but please revisit on top of just the
tegra code and let me know.

Yes, that's expected. I should have mentioned that this patch depends on
changes in the new series that added the new Tegra pinctrl driver, but
that hasn't been applied to the Tegra branches since I need to rework the
Tegra board files for changes in the pinctrl API etc. I'll repost patches
once all the pinctrl rework is finalized.

-- 
nvpublic