[PATCH 0/2 v5] arm: kirkwood: add dreamplug/devicetree support

On Thu, 2012-02-23 at 19:52 +0000, Jason Cooper wrote:

This patch series provides initial support for devicetree on kirkwood for the
dreamplug platform.  After discussing the approach with Arnd Bergman last week
at ELC, we decided to take an incremental approach to the conversion.  First, I
would detect that we were on the dreamplug via the devicetree blob.  Then,
configure uart0 via devicetree.  We chose the uart since it is already well
supported under devicetree.

This patch series has been boot-tested on the dreamplug.

Tested-by: Ian Campbell <redacted>

I needed the following (obvious) patch against u-boot:

diff --git a/include/configs/dreamplug.h b/include/configs/dreamplug.h
index 0f2f9a2..76f9eea 100644
--- a/include/configs/dreamplug.h
+++ b/include/configs/dreamplug.h

@@ -148,4 +148,6 @@
  */
 #define CONFIG_DISPLAY_CPUINFO
 
+#define CONFIG_OF_LIBFDT
+
 #endif /* _CONFIG_DREAMPLUG_H */

Ian.