[PATCH] mach-ux500: add devicetree compat nodes

On Fri, Nov 11, 2011 at 5:38 PM, Rob Herring [off-list ref] wrote:

[Me]

quoted

In that case we should hold this patch off and only keep it for
internal testing until all necessary drivers are ready and patched
so we can replace all board files with a single DT-based one,
instead of this compromise solution.

I would not hold off. You only need to have a minimal set that's enough
to boot.

In our case UART, I2C and MMC is necessary to boot, so then we
anyway need to wait for these to be patched first. So we'd better hold
it back for now I think.

Linus Walleij