Use generic gpio call to check the validity of the gpio. Note that
this includes gpio 0 also which was missing before.

Signed-off-by: Silesh C V <redacted>
---
?arch/arm/mach-omap2/hsmmc.c | ? ?7 +++----
?1 files changed, 3 insertions(+), 4 deletions(-)

diff --git a/arch/arm/mach-omap2/hsmmc.c b/arch/arm/mach-omap2/hsmmc.c
index 66868c5..a9b45c7 100644
--- a/arch/arm/mach-omap2/hsmmc.c
+++ b/arch/arm/mach-omap2/hsmmc.c

@@ -13,6 +13,7 @@

?#include <linux/slab.h>
?#include <linux/string.h>
?#include <linux/delay.h>
+#include <linux/gpio.h>
?#include <mach/hardware.h>
?#include <plat/mmc.h>
?#include <plat/omap-pm.h>

@@ -213,12 +214,10 @@ static int nop_mmc_set_power(struct device *dev, int slot, int power_on,

?static inline void omap_hsmmc_mux(struct omap_mmc_platform_data *mmc_controller,
? ? ? ? ? ? ? ? ? ? ? ?int controller_nr)
?{
- ? ? ? if ((mmc_controller->slots[0].switch_pin > 0) && \
- ? ? ? ? ? ? ? (mmc_controller->slots[0].switch_pin < OMAP_MAX_GPIO_LINES))
+ ? ? ? if (gpio_is_valid(mmc_controller->slots[0].switch_pin))
? ? ? ? ? ? ? ?omap_mux_init_gpio(mmc_controller->slots[0].switch_pin,
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?OMAP_PIN_INPUT_PULLUP);
- ? ? ? if ((mmc_controller->slots[0].gpio_wp > 0) && \
- ? ? ? ? ? ? ? (mmc_controller->slots[0].gpio_wp < OMAP_MAX_GPIO_LINES))
+ ? ? ? if (gpio_is_valid(mmc_controller->slots[0].gpio_wp))
? ? ? ? ? ? ? ?omap_mux_init_gpio(mmc_controller->slots[0].gpio_wp,
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?OMAP_PIN_INPUT_PULLUP);
? ? ? ?if (cpu_is_omap34xx()) {
--
1.7.1