[PATCH v4 1/4] mmc: sdhci: fix interrupt storm from card detection

The issue was initially found by Eric Benard as below.

http://permalink.gmane.org/gmane.linux.ports.arm.kernel/108031

Not sure about other SDHCI based controller, but on Freescale eSDHC,
the SDHCI_INT_CARD_INSERT bits will be immediately set again when it
gets cleared, if a card is inserted. The driver need to mask the irq
to prevent interrupt storm which will freeze the system.  And the
SDHCI_INT_CARD_REMOVE gets the same situation.

The patch fixes the problem based on the initial idea from
Eric Benard.

Signed-off-by: Shawn Guo <redacted>
Cc: Eric Benard <redacted>
Tested-by: Arnaud Patard <redacted>
---
drivers/mmc/host/sdhci.c |   29 +++++++++++++++++++++++++----
1 files changed, 25 insertions(+), 4 deletions(-)

diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index 91d9892..790f959 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c

@@ -127,11 +127,15 @@ static void sdhci_mask_irqs(struct sdhci_host *host, u32 irqs)

static void sdhci_set_card_detection(struct sdhci_host *host, bool enable)
{
-	u32 irqs = SDHCI_INT_CARD_REMOVE | SDHCI_INT_CARD_INSERT;
+	u32 present, irqs;

	if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION)
		return;

+	present = sdhci_readl(host, SDHCI_PRESENT_STATE) &
+			      SDHCI_CARD_PRESENT;
+	irqs = present ? SDHCI_INT_CARD_REMOVE : SDHCI_INT_CARD_INSERT;
+
	if (enable)
		sdhci_unmask_irqs(host, irqs);
	else

@@ -2154,13 +2158,30 @@ static irqreturn_t sdhci_irq(int irq, void *dev_id)

		mmc_hostname(host->mmc), intmask);

	if (intmask & (SDHCI_INT_CARD_INSERT | SDHCI_INT_CARD_REMOVE)) {
+		u32 present = sdhci_readl(host, SDHCI_PRESENT_STATE) &
+			      SDHCI_CARD_PRESENT;
+
+		/*
+		 * There is a observation on i.mx esdhc.  INSERT bit will be
+		 * immediately set again when it gets cleared, if a card is
+		 * inserted.  We have to mask the irq to prevent interrupt
+		 * storm which will freeze the system.  And the REMOVE gets
+		 * the same situation.
+		 *
+		 * More testing are needed here to ensure it works for other
+		 * platforms though.
+		 */
+		sdhci_mask_irqs(host, present ? SDHCI_INT_CARD_INSERT :
+						SDHCI_INT_CARD_REMOVE);
+		sdhci_unmask_irqs(host, present ? SDHCI_INT_CARD_REMOVE :
+						  SDHCI_INT_CARD_INSERT);
+