[PATCH v3 2/3] omap3: beaglexm: fix DVI reset GPIO
From: nm@ti.com (Nishanth Menon)
Date: 2011-01-06 19:54:38
Also in:
linux-omap
Subsystem:
arm port, omap2+ support, the rest · Maintainers:
Russell King, Aaro Koskinen, Andreas Kemnade, Kevin Hilman, Roger Quadros, Tony Lindgren, Linus Torvalds
From: Koen Kooi <redacted> GPIO reset line for Beagle XM is different from vanilla beagle so we populate it as part of gpio update routine. Signed-off-by: Nishanth Menon <nm@ti.com> Signed-off-by: Koen Kooi <redacted> --- arch/arm/mach-omap2/board-omap3beagle.c | 8 +++++++- 1 files changed, 7 insertions(+), 1 deletions(-)
diff --git a/arch/arm/mach-omap2/board-omap3beagle.c b/arch/arm/mach-omap2/board-omap3beagle.c
index 1b5aa7a..d628f5e 100644
--- a/arch/arm/mach-omap2/board-omap3beagle.c
+++ b/arch/arm/mach-omap2/board-omap3beagle.c@@ -199,7 +199,7 @@ static struct omap_dss_device beagle_dvi_device = { .name = "dvi", .driver_name = "generic_panel", .phy.dpi.data_lines = 24, - .reset_gpio = 170, + .reset_gpio = -EINVAL, .platform_enable = beagle_enable_dvi, .platform_disable = beagle_disable_dvi, };
@@ -308,6 +308,12 @@ static int beagle_twl_gpio_setup(struct device *dev, else gpio_direction_output(gpio + TWL4030_GPIO_MAX, 0); + /* DVI reset GPIO is different between beagle revisions */ + if (omap3_beagle_get_rev() == OMAP3BEAGLE_BOARD_XM) + beagle_dvi_device.reset_gpio = 129; + else + beagle_dvi_device.reset_gpio = 170; + /* TWL4030_GPIO_MAX + 1 == ledB, PMU_STAT (out, active low LED) */ gpio_leds[2].gpio = gpio + TWL4030_GPIO_MAX + 1;
--
1.6.3.3