[PATCH v4 5/8] arm: mxc: move IOMUX_CONFIG_XXXX definitions to iomux-v3.h

Sascha Hauer [off-list ref] writes:
Hi,

On Thu, Jan 06, 2011 at 02:59:36PM +0800, Richard Zhao wrote:

quoted

Hello Sascha,

On Thu, Dec 30, 2010 at 07:25:04PM +0800, Richard Zhao wrote:

quoted

IOMUX_CONFIG_GPIO is not for iomux-v3. It's for old freescale
iomux routines. Remove it.

Signed-off-by: Richard Zhao <redacted>
Acked-by: Uwe Kleine-K?nig <redacted>

If you don't have comments, could you please merge this patch?
It's causing arch/arm/plat-mxc/include/mach/iomux-mx50.h incomplete.

I didn't apply it because it conflicts with current imx-for-2.6.38
branch. Other than that I don't find the enum very useful at all,
because we have problems with very long lines in these files and
using IOMUX_CONFIG_ALT0 where we could use 0 does not exactly improve
the situation.

While I agree with this, there's a small exception. I found out
yesterday that now, there's no more any macro/enum defined for the
infamous SION bit. Theses means that currently to defined a PAD with
SION bit set, we have to create a new macro with IOMUX_PAD instead
of using the _MX51_PAD_* macro as basis. Did I miss something ?

Arnaud