Vishwanath Sripathy [off-list ref] writes:

[...]

quoted

Please note the following log when enabling SR in Class 3 on an
OMAP4430/sdp:

[    2.362182] omap2_set_init_voltage: unable to find boot up OPP for
vdd_mpu
[    2.369384] omap2_set_init_voltage: Unable to put vdd_mpu to its init
voltage
[    2.369384]
[    2.378875] omap2_set_init_voltage: unable to find boot up OPP for
vdd_iva
[    2.386108] omap2_set_init_voltage: Unable to put vdd_iva to its init
voltage
[    2.386108]
[    2.396484] Power Management for TI OMAP4.
[    2.401031] sr_init: No PMIC hook to init smartreflex
[    2.406494] smartreflex smartreflex.0: omap_sr_probe: SmartReflex
driver initialized
[    2.414825] smartreflex smartreflex.1: omap_sr_probe: SmartReflex
driver initialized
[    2.423187] smartreflex smartreflex.2: omap_sr_probe: SmartReflex
driver initialized
[    2.431732] SmartReflex Class3 initialized

Is it expected?
Why do we have that blank line in-between?

I think turbo OPPs are disabled by default in OPP table where as uboot is
setting mpu and iva to turbo OPP. That's why you are getting this error.

That explains the MPU OPPs, but only raises more questions.  On what
platforms was this tested?  with *and* without turbo OPPs enabled?  Does
the voltage layer properly initialized if the boot up OPP is not found,
and the initial voltage is not set?

You should not get this error if you enable turbo opps in opp table.

You would still get missing boot up OPP for IVA, as there are currenly
no OMAP4 OPPs for IVA.  Again, begging the question... how was this
tested.

Kevin