[PATCH v4] Samsung: add new card detection methods in s3c-sdhci driver (platform part)

Marek Szyprowski wrote:

On some Samsung SoCs not all SDHCI controllers have card detect (CD)
line. For some embedded designs it is not even needed, because ususally
the device (like SDIO flash memory or wifi controller) is permanently
wired to the controller. There are also systems which have a card detect
line connected to some of the external interrupt lines or the presence
of the card depends on some other actions (like enabling a power
regulator).

This patch adds all required changes to platform support code, so
another patch, which extends the driver with support for the new card
detection methods can be applied.

Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
Signed-off-by: Kyungmin Park <kyungmin.park@samsung.com>

Ok..will apply soon.

Thanks.

Best regards,
Kgene.
--
Kukjin Kim [off-list ref], Senior Engineer,
SW Solution Development Team, Samsung Electronics Co., Ltd.

---

This a resend of the previous patch.

I hope these changes to platform specific code gets merged soon, so the
changes to the driver can be merged as well.

The patch has been prepared against linux-next kernel tree from 20100722.

Changes since V3:
- renamed patch to avoid confusion with the patch for the s3c-sdhci driver
  itself - added "(platform part)" in subject

Changes since V2:
- added support for HSMMC3 device

Changes since V1:
- added support for gpio external interrupt card based detect method
  directly to sdhci-s3c driver
- removed s3c64xx compilation fix patch from the series

Best regards
--
Marek Szyprowski
Samsung Poland R&D Center