[PATCH v2 05/20] omap zoom3: wlan board muxing
flat view
STALE5925d
SUPERSEDED
From: Ohad Ben-Cohen <hidden>
Date: 2010-07-21 17:33:39
Also in:
linux-mmc, linux-omap, linux-wireless
Subsystem:
arm port, omap2+ support, the rest · Maintainers:
Russell King, Aaro Koskinen, Andreas Kemnade, Kevin Hilman, Roger Quadros, Tony Lindgren, Linus Torvalds
Status: Superseded by v4 (posted 2010-08-11). [go to v4]
Revision v2 (3 revisions archived).
Revisions (3)
- v2 current
- v3 [diff against previous]
- v4 [diff against previous]
Add board muxing to support the wlan wl1271 chip that is hardwired to mmc2 (third mmc controller) on the ZOOM3. Signed-off-by: Ohad Ben-Cohen <redacted> --- arch/arm/mach-omap2/board-zoom3.c | 13 +++++++++++++ 1 files changed, 13 insertions(+), 0 deletions(-)
diff --git a/arch/arm/mach-omap2/board-zoom3.c b/arch/arm/mach-omap2/board-zoom3.c
index 3314704..7d17046 100644
--- a/arch/arm/mach-omap2/board-zoom3.c
+++ b/arch/arm/mach-omap2/board-zoom3.c@@ -46,6 +46,19 @@ static void __init omap_zoom_init_irq(void) #ifdef CONFIG_OMAP_MUX static struct omap_board_mux board_mux[] __initdata = { + /* WLAN IRQ - GPIO 162 */ + OMAP3_MUX(MCBSP1_CLKX, OMAP_MUX_MODE4 | OMAP_PIN_INPUT_PULLUP), + /* WLAN POWER ENABLE - GPIO 101 */ + OMAP3_MUX(CAM_D2, OMAP_MUX_MODE4 | OMAP_PIN_OUTPUT), + /* WLAN SDIO: MMC3 CMD */ + OMAP3_MUX(MCSPI1_CS1, OMAP_MUX_MODE3 | OMAP_PIN_INPUT_PULLUP), + /* WLAN SDIO: MMC3 CLK */ + OMAP3_MUX(ETK_CLK, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP), + /* WLAN SDIO: MMC3 DAT[0-3] */ + OMAP3_MUX(ETK_D3, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP), + OMAP3_MUX(ETK_D4, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP), + OMAP3_MUX(ETK_D5, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP), + OMAP3_MUX(ETK_D6, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP), { .reg_offset = OMAP_MUX_TERMINATOR }, }; #else
--
1.7.0.4