On Thu, Jun 17, 2021 at 11:48 PM Matteo Croce
[off-list ref] wrote:

On Thu, Jun 17, 2021 at 11:30 PM David Laight [off-list ref] wrote:

quoted

From: Matteo Croce

quoted

Sent: 16 June 2021 19:52
To: Guo Ren <guoren@kernel.org>

On Wed, Jun 16, 2021 at 1:46 PM Guo Ren [off-list ref] wrote:

quoted

Hi Matteo,

Have you tried Glibc generic implementation code?
ref: https://lore.kernel.org/linux-arch/20190629053641.3iBfk9-

I_D29cDp9yJnIdIg7oMtHNZlDmhLQPTumhEc@z/#t

quoted

If Glibc codes have the same performance in your hardware, then you
could give a generic implementation first.

Isn't that a byte copy loop - the performance of that ought to be terrible.
...

quoted

I had a look, it seems that it's a C unrolled version with the
'register' keyword.
The same one was already merged in nios2:
https://elixir.bootlin.com/linux/latest/source/arch/nios2/lib/memcpy.c#L68

I know a lot about the nios2 instruction timings.
(I've looked at code execution in the fpga's intel 'logic analiser.)
It is a very simple 4-clock pipeline cpu with a 2-clock delay
before a value read from 'tightly coupled memory' (aka cache)
can be used in another instruction.
There is also a subtle pipeline stall if a read follows a write
to the same memory block because the write is executed one
clock later - and would collide with the read.
Since it only ever executes one instruction per clock loop
unrolling does help - since you never get the loop control 'for free'.
OTOH you don't need to use that many registers.
But an unrolled loop should approach 2 bytes/clock (32bit cpu).

quoted

I copied _wordcopy_fwd_aligned() from Glibc, and I have a very similar
result of the other versions:

[  563.359126] Strings selftest: memcpy(src+7, dst+7): 257 Mb/s

What clock speed is that running at?
It seems very slow for a 64bit cpu (that isn't an fpga soft-cpu).

While the small riscv cpu might be similar to the nios2 (and mips
for that matter), there are also bigger/faster cpu.
I'm sure these can execute multiple instructions/clock
and possible even read and write at the same time.
Unless they also support significant instruction re-ordering
the trivial copy loops are going to be slow on such cpu.

It's running at 1 GHz.

I get 257 Mb/s with a memcpy, a bit more with a memset,
but I get 1200 Mb/s with a cyle which just reads memory with 64 bit addressing.

Err, I forget a mlock() before accessing the memory in userspace.

The real speed here is:

8 bit read: 155.42 Mb/s
64 bit read: 277.29 Mb/s
8 bit write: 138.57 Mb/s
64 bit write: 239.21 Mb/s

-- 
per aspera ad upstream