On Wed, May 18, 2022 at 04:50:05PM -0700, Eric Biggers wrote:

From: Eric Biggers <redacted>

Traditionally, the conditions for when DIO (direct I/O) is supported
were fairly simple: filesystems either supported DIO aligned to the
block device's logical block size, or didn't support DIO at all.

However, due to filesystem features that have been added over time (e.g,
data journalling, inline data, encryption, verity, compression,
checkpoint disabling, log-structured mode), the conditions for when DIO
is allowed on a file have gotten increasingly complex.  Whether a
particular file supports DIO, and with what alignment, can depend on
various file attributes and filesystem mount options, as well as which
block device(s) the file's data is located on.

XFS has an ioctl XFS_IOC_DIOINFO which exposes this information to
applications.  However, as discussed
(https://lore.kernel.org/linux-fsdevel/20220120071215.123274-1-ebiggers@kernel.org/T/#u (local)),
this ioctl is rarely used and not known to be used outside of
XFS-specific code.  It also was never intended to indicate when a file
doesn't support DIO at all, and it only exposes the minimum I/O
alignment, not the optimal I/O alignment which has been requested too.

Therefore, let's expose this information via statx().  Add the
STATX_IOALIGN flag and three fields associated with it:

* stx_mem_align_dio: the alignment (in bytes) required for user memory
  buffers for DIO, or 0 if DIO is not supported on the file.

* stx_offset_align_dio: the alignment (in bytes) required for file
  offsets and I/O segment lengths for DIO, or 0 if DIO is not supported
  on the file.  This will only be nonzero if stx_mem_align_dio is
  nonzero, and vice versa.

* stx_offset_align_optimal: the alignment (in bytes) suggested for file
  offsets and I/O segment lengths to get optimal performance.  This
  applies to both DIO and buffered I/O.  It differs from stx_blocksize
  in that stx_offset_align_optimal will contain the real optimum I/O
  size, which may be a large value.  In contrast, for compatibility
  reasons stx_blocksize is the minimum size needed to avoid page cache
  read/write/modify cycles, which may be much smaller than the optimum
  I/O size.  For more details about the motivation for this field, see
  https://lore.kernel.org/r/20220210040304.GM59729@dread.disaster.area (local)

Note that as with other statx() extensions, if STATX_IOALIGN isn't set
in the returned statx struct, then these new fields won't be filled in.
This will happen if the filesystem doesn't support STATX_IOALIGN, or if
the file isn't a regular file.  (It might be supported on block device
files in the future.)  It might also happen if the caller didn't include
STATX_IOALIGN in the request mask, since statx() isn't required to
return information that wasn't requested.

This commit adds the VFS-level plumbing for STATX_IOALIGN.  Individual
filesystems will still need to add code to support it.

Signed-off-by: Eric Biggers <redacted>
---

Looks good to me,
Reviewed-by: Christian Brauner (Microsoft) <brauner@kernel.org>