Re: [PATCH v4 03/13] task_isolation: userspace hard isolation from kernel

+/**
+ * task_isolation_kernel_enter() - clear low-level task isolation flag
+ *
+ * This should be called immediately after entering kernel.
+ */
+static inline void task_isolation_kernel_enter(void)
+{
+	unsigned long flags;
+
+	/*
+	 * This function runs on a CPU that ran isolated task.
+	 *
+	 * We don't want this CPU running code from the rest of kernel
+	 * until other CPUs know that it is no longer isolated.
+	 * When CPU is running isolated task until this point anything
+	 * that causes an interrupt on this CPU must end up calling this
+	 * before touching the rest of kernel. That is, this function or
+	 * fast_task_isolation_cpu_cleanup() or stop_isolation() calling
+	 * it. If any interrupt, including scheduling timer, arrives, it
+	 * will still end up here early after entering kernel.
+	 * From this point interrupts are disabled until all CPUs will see
+	 * that this CPU is no longer running isolated task.
+	 *
+	 * See also fast_task_isolation_cpu_cleanup().
+	 */
+	smp_rmb();

+	if((this_cpu_read(ll_isol_flags) & FLAG_LL_TASK_ISOLATION) == 0)
+		return;
+
+	local_irq_save(flags);
+
+	/* Clear low-level flags */
+	this_cpu_write(ll_isol_flags, 0);
+
+	/*
+	 * If something happened that requires a barrier that would
+	 * otherwise be called from remote CPUs by CPU kick procedure,
+	 * this barrier runs instead of it. After this barrier, CPU
+	 * kick procedure would see the updated ll_isol_flags, so it
+	 * will run its own IPI to trigger a barrier.
+	 */
+	smp_mb();
+	/*
+	 * Synchronize instructions -- this CPU was not kicked while
+	 * in isolated mode, so it might require synchronization.
+	 * There might be an IPI if kick procedure happened and
+	 * ll_isol_flags was already updated while it assembled a CPU
+	 * mask. However if this did not happen, synchronize everything
+	 * here.
+	 */
+	instr_sync();