Re: [PATCH 13/14] twl4030_charger: Increase current carefully while watching voltage.

Hi!

The USB Battery Charging spec (BC1.2) suggests a dedicated
charging port can deliver from 0.5 to 5.0A at between 4.75 and 5.25
volts.

To choose the "correct" current voltage setting requires a trial
and error approach: try to draw current and see if the voltage drops
too low.

Even with a configured Standard Downstream Port, it may not be possible
to reliably pull 500mA - depending on cable quality and source
quality I have reports of charging failure due to the voltage dropping
too low.

To address both these concerns, this patch introduce incremental
current setting.
The current pull from VBUS is increased in steps of 20mA every 100ms
until the target is reached or until the measure voltage drops below
4.75V.  If the voltage does go too low, the target current is reduced
by 20mA and kept there.

Still nervous. If it is possible to overheat the charger, without
tripping internal fuse, then you'll do it.

This applies to currents selected automatically, or to values
set via sysfs.  So setting a large value will cause the maximum
available to be used - up to the limit of 1.7A imposed by the
hardware.

+	printk("v=%d cur=%d target=%d\n", v, bci->usb_cur,
+	       bci->usb_cur_target);

dev_info() and a bit better message, or drop it for production?

More importantly.... how does it work with device drawing power for
operation, too?

Imagine device need 500mA with wifi hotspot, nearly nothing while idle.

Idle device. Code will find that it can charge using 1A, backs up to
0.9A. User starts hotspot. Now device will draw 1.4A, overloading the
charger and not charging at all...?

Best regards,
									Pavel
-- 
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html