@@ -203,7 +203,7 @@ static void unimac_mdio_clk_set(struct unimac_mdio_priv *priv)
 		return;
 	}
 
-	/* The MDIO clock is the reference clock (typicaly 250Mhz) divided by
+	/* The MDIO clock is the reference clock (typically 250Mhz) divided by
 	 * 2 x (MDIO_CLK_DIV + 1)
 	 */
 	reg = unimac_mdio_readl(priv, MDIO_CFG);

@@ -65,7 +65,7 @@ static void mdio_mux_iproc_config(struct iproc_mdiomux_desc *md)
 	writel(val, md->base + MDIO_SCAN_CTRL_OFFSET);
 
 	if (md->core_clk) {
-		/* use rate adjust regs to derrive the mdio's operating
+		/* use rate adjust regs to derive the mdio's operating
 		 * frequency from the specified core clock
 		 */
 		divisor = clk_get_rate(md->core_clk) / MDIO_OPERATING_FREQUENCY;

@@ -95,7 +95,7 @@ static int g12a_ephy_pll_enable(struct clk_hw *hw)
 
 	/* Poll on the digital lock instead of the usual analog lock
 	 * This is done because bit 31 is unreliable on some SoC. Bit
-	 * 31 may indicate that the PLL is not lock eventhough the clock
+	 * 31 may indicate that the PLL is not lock even though the clock
 	 * is actually running
 	 */
 	return readl_poll_timeout(pll->base + ETH_PLL_CTL0, val,

@@ -466,7 +466,7 @@ EXPORT_SYMBOL(of_phy_get_and_connect);
  * of_phy_is_fixed_link() and of_phy_register_fixed_link() must
  * support two DT bindings:
  * - the old DT binding, where 'fixed-link' was a property with 5
- *   cells encoding various informations about the fixed PHY
+ *   cells encoding various information about the fixed PHY
  * - the new DT binding, where 'fixed-link' is a sub-node of the
  *   Ethernet device.
  */