On Sun, Mar 11, 2012 at 07:47:27PM +0530, santosh prasad nayak wrote:

Not to use in_atomic()  in driver code.

 Following article  inspired me to do the change.
http://lwn.net/Articles/274695/

"in_atomic() is for core kernel use only. Because in special
circumstances (ie: kmap_atomic()) we run inc_preempt_count() even on
non-preemptible kernels to tell the per-arch fault handler that it was
invoked by copy_*_user() inside kmap_atomic(), and it must fail.
In other words, in_atomic() works in a specific low-level situation,
but it was never meant to be used in a wider context. Its placement in
hardirq.h next to macros which can be used elsewhere was, thus, almost
certainly a mistake. As Alan Stern pointed out, the fact that Linux
Device Drivers recommends the use of in_atomic() will not have helped
the situation. Your editor recommends that the authors of that book be
immediately sacked. "

In the present case, we just check whether its an IRQ context or user
context. So for that
we can use "in_interrupt()".

Greg also mentions the same in the following mail.
http://www.spinics.net/lists/newbies/msg43402.html

In which case, we'll just have to do mdelay() and forget about allowing
anything else to run for the 20ms that we need to sleep.  Sucky but
that's the way things are.