Hi

On Thu, Jun 15, 2023, at 19:46, eric.frederich@siemens.com wrote:

I am able to produce a commit with a trailer which does not show up in:
    `git log
--format="%(trailers:key=old-scm-change-id,valueonly,separator=%x2c) %H
%T" HEAD`
But does show up in:
    `git cat-file commit HEAD | git interpret-trailers --parse`

It seems that the `--- ` (note the space) is interpreted as marking the
start of the patch part (as in a patch file which contains a commit
message followed by a patch).

See `trailers.c:find_patch_start` (here on d7d8841f67 (Start the 2.42
cycle, 2023-06-13):

	for (s = str; *s; s = next_line(s)) {
		const char *v;

		if (skip_prefix(s, "---", &v) && isspace(*v))
			return s - str;
	}

I’m not good with C but it seems that this line will match:

    --- let's mess stuff up ---

Which instructs the code to put the trailer *before* this “patch part”.

(Or at least: if I remove this if-block then your script seems to work
like you want it to.)

This seems to be in line with the documentation in `man git
interpret-trailers`:

The group must either be at the end of the message or be the last
non-whitespace lines before a line that starts with --- (followed
by a space or the end of the line). Such three minus signs start
the patch part of the message. See also --no-divider below.

Note “by a space or the end of the line”.

This check used to be simpler: before it only checked for a line that
started with `---`, no matter what came after on that line. But that was
changed to match on `---` followed by `isspace(v*)` in c188668e38
(interpret-trailers: tighten check for "---" patch boundary,
2018-08-22). Reading the commit message it seems that the change was
conservative. Maybe it would have been more strict (like demanding only
lines like either `---\n` or `---\n `) if there weren’t concerns about
how the behavior had been documented to match loosely up until that
point.

(+Cc the commit author)

-- 
Kristoffer Haugsbakk