Re: data loss when doing ls-remote and piped to command

On Thu, Sep 16, 2021 at 11:59 PM Rolf Eike Beer [off-list ref] wrote:

When I run the whole thing with strace I can't see the effect, which isn't
really surprising. But there is a difference between the cases where I run
with redirection "2>&1":

ioctl(2, TCGETS, 0x7ffd6f119b10)        = -1 ENOTTY (Inappropriate ioctl for device)

Ehh. That format of strace implies that you didn't use "strace -f"
(which would have the PID in it).

Although maybe you edited it out.

I think the error output would come from the other process (ssh, or
whatever process you use to run "git-upload-pack" on the other end).

I still strongly doubt it's about pipes - we've had changes to them,
but if they are broken we'd see a lot more breakage than some very
incidental use by git.

But I can easily see it being timing-dependent. And yes, sadly
'strace' can often end up hiding any timing issues because it
obviously slows down the target quite a bit.

Doing "strace -o tracefile -f" in a loop would be interesting if you
can reproduce it (and then stop when you reproduce it, so that the
final 'tracefile' is the one for the case that reproduced it).

            Linus