Re: The error subcommand given by git tab completion.

git gui works normally for me in arch.
You should go to install some dependent commands.

Hongyi Zhao [off-list ref] 于2021年2月1日周一 下午11:19写道：

On Ubuntu 20.04, the `git TAB' will give me the following available subcommands:

$ git TAB
add               deborig           merge             rm
am                describe          mergetool         send-email
apply             diff              mv                shortlog
archive           difftool          notes             show
bisect            fetch             pull              show-branch
blame             format-patch      push              sparse-checkout
branch            fsck              range-diff        stage
bundle            gc                rebase            stash
checkout          gitk              reflog            status
cherry            grep              remote            submodule
cherry-pick       gui               repack            switch
citool            help              replace           tag
clean             init              request-pull      whatchanged
clone             instaweb          reset             worktree
commit            latexdiff         restore
config            log               revert

Then I try the following:

$ git gui
git: 'gui' is not a git command. See 'git --help'.

The most similar commands are
    gc
    grep
    init
    pull
    push

The git version is shown as below:

$ git --version
git version 2.25.1

As you can see, gui is among the auto-completed subcommands list, but
it can be run like the manner of other subcommands. Any hints for this
problem?

Regards
--
Assoc. Prof. Hongyi Zhao [off-list ref]
Theory and Simulation of Materials
Hebei Polytechnic University of Science and Technology engineering
NO. 552 North Gangtie Road, Xingtai, China