Re: [dpdk-dev] Promiscuous Mode Feature

On Thu, Jun 25, 2020 at 4:23 PM Ajit Khaparde [off-list ref]
wrote:

On Wed, Jun 24, 2020 at 1:03 PM Thomas Monjalon [off-list ref]
wrote:

quoted

Hi,

A bit of context: David is going to implement a test in DTS
for promiscuous mode:
http://doc.dpdk.org/guides/nics/features.html#promiscuous-mode

24/06/2020 18:18, David Liu:

quoted

Hi all,

From my understanding, the promiscuous mode feature will verify the
functionality of promiscuous mode when it is on or off.

You need to check in which condition the promiscuous mode can be enabled.
Some contexts may forbid this mode. untrusted VF? flow isolation mode?

But there is no way other than some logs to indicate these.
Maybe we should add some state in port info to indicate this?

 From what I know, I not sure if that is possible to add these states into
the test case?
 But let me know what you think.

quoted

quoted

The plan for testing this feature is as follows:

Sending over a packet to verify the ports are working properly before

any

quoted

testing. First to verify the promiscuous mode is enabled. With the
promiscuous being enabled, send over a packet and check if the packet

will

quoted

be received when sending it to a different destination mac address than

the

quoted

host/card. Then disable the promiscuous mode. The packet will only be
received if the mac address is the destination mac address. Otherwise,

the

quoted

test case will be considered a failure.

I assume you will test positive and negative in both on/off cases.

Yes, in the test case. It covered sending a packet with same/different

destination mac address
when promiscuous is on/off.

Please let me know if there is anything I need to add on or if there are

quoted

quoted

certain cases I need to be aware of.

Anyone else has ideas about what to test and corner cases?

quoted

Thanks,
David Liu
UNH Interoperability Lab