On 3/17/2017 10:45 AM, Qi Zhang wrote:

Add below command line to configure ptype mapping.
ptype mapping get <port_id> <valid_only>.
ptype mapping replace <port_id> <target> <mask> <pkt_type>.
ptype mapping reset <port_id>.
ptype mapping update <port_id> <hw_ptype> <sw_ptype>.

Signed-off-by: Qi Zhang <redacted>

<...>

+static void
+cmd_ptype_mapping_get_parsed(
+	void *parsed_result,
+	__attribute__((unused)) struct cmdline *cl,
+	__attribute__((unused)) void *data)
+{
+	struct cmd_ptype_mapping_get_result *res = parsed_result;
+	int ret = -ENOTSUP;
+#ifdef RTE_LIBRTE_I40E_PMD
+	int max_ptype_num = 256;
+	struct rte_pmd_i40e_ptype_mapping mapping[max_ptype_num];
+	uint16_t count;
+	int i;
+#endif
+
+	if (port_id_is_invalid(res->port_id, ENABLED_WARN))
+		return;
+
+#ifdef RTE_LIBRTE_I40E_PMD
+	ret = rte_pmd_i40e_ptype_mapping_get(res->port_id,
+					mapping,
+					max_ptype_num,
+					&count,
+					res->valid_only);
+#endif
+
+	switch (ret) {
+	case 0:
+		break;
+	case -ENODEV:
+		printf("invalid port_id %d\n", res->port_id);
+		break;
+	case -ENOTSUP:
+		printf("function not implemented\n");
+		break;
+	default:
+		printf("programming error: (%s)\n", strerror(-ret));
+	}
+
+#ifdef RTE_LIBRTE_I40E_PMD
+	if (!ret) {
+		for (i = 0; i < count; i++)
+			printf("%3d\t0x%08x\n",
+				mapping[i].hw_ptype, mapping[i].sw_ptype);
+	}
+#endif

Why this #ifdef exists?
I thinks only wrapping the API with #ifdef should be enough, like other
commands in this patch?