Re: [B.A.T.M.A.N.] ap_isolation issue

Ok, I have added the requested information to the pastebin:

	http://pastebin.com/dpF4cp8t

You are implying that disabling and then re-enabling the ap isolation also 
fixes the "ping problem" ? 

 
Yes, I see the configmation in the logs that ap_isolation was turned on but contrary to 'cold boot' condition where ap_isolation is on, the ping works when doing a disable/enable cycle.

What happens if you disable the bridge loop avoidance ? Does it have any 
effect ?

I'll test that and report.


On 2012-01-26, at 2:13 PM, Marek Lindner wrote:

Hi,

quoted

 We are trying to get OpenWRT with batman-adv 2011.4.0 to play nice using
ap_isolation. However as soon as ap_isolation is turned on the meshed ap
are not acessible anymore by our Linux firewall on which at least 1 ap
node is physically connected. The following pastebin post shows the exact
configuration and details:

	http://pastebin.com/2bghWLkp

how is the Linux firewall connected to batman-adv-AP#1 ? Via eth0 ? 
Can you please also add the output of "batctl if" and "batctl sn" on all 
devices ?

What happens if you disable the bridge loop avoidance ? Does it have any 
effect ?

You are implying that disabling and then re-enabling the ap isolation also 
fixes the "ping problem" ? 

Regards,
Marek